Verint Nextiva S2750e Series Guía de instalación descargar pdf (Pagina 2)

Nextiva S2750e Series Installation Guide

www.verint.com/manuals 2

Mounting

Preparation

1. Remove the outer case by loosening the two case screws with a

Phillips screwdriver.

2. If you are mounting the camera on the ceiling or wall, mark the four

positions for fixing the dome base on the mounting surface, then

make the four holes.

If you are mounting the camera on an electrical box, you will use only

two of the four mounting holes on the dome base.

3. If you are using the base cable entry, replace the plastic cap by the

supplied rubber cap, then make a hole at the desired location on the

mounting surface.

Outer case

Outer case screw

Dome base

Mounting holes

Base cable entry

Side cable entry

1 2 3 4

Sin comentarios

Verint Nextiva S2750e Series Guía de instalación Pagina 2