Verint Nextiva S1700e Series Manual de usuario descargar pdf (Pagina 18)

1: Getting Started

6 Verint Video Solutions

2. If required, change the IP address of the computer and the

detection scope.

3. To change the configurable VSIP port, do one of the

following steps:

 In the VSIP Port field, type its new value.

 To reset it to its default value, click Default.

 To set it to the common value, click Common.

4. To set the discovery IP address, click Reset to Broadcast

or Reset to Multicast depending on your supported

discovery method.

5. Click OK.

SSL

You can enable the SSL protocol between SConfigurator and

Nextiva devices. This way, VSIP communication occurring on

the IP network will be secure. For more information about SSL,

see the “Enabling Security” chapter on page 53.

By default, SConfigurator can communicate with devices

holding an SSL certificate (SSL-enabled devices) as well as

non-SSL devices. However, you can increase security by forcing

SConfigurator to communicate only with SSL-enabled devices

that it trusts and that share the same SSL passkey.

The SConfigurator SSL settings are:

 Trusted Unit List—The list of trusted Nextiva devices that

SConfigurator will manage in a secure system.

 Enable Security—The indication of whether SConfigurator

can communicate only with SSL-enabled devices that are

included in the trusted list and that share the same SSL

passkey.

 Enter SSL Passkey—To change the password shared by

SConfigurator and SSL-enabled devices to establish a

secure VSIP connection.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 98 99

Sin comentarios

Verint Nextiva S1700e Series Manual de usuario Pagina 18