Verint Nextiva S1700e Series Manual de usuario descargar pdf (Pagina 84)

A: DHCP Support and APIPA Service

72 Verint Video Solutions

At startup, an edge device searches for a valid IP network

configuration. The device requires this configuration prior to

starting its functions. The network configuration for Nextiva

devices consists of:

 An IP address

 A subnet mask

 A gateway

The device first looks in its local memory. If no configuration is

found, it tries to contact a DHCP server. If DHCP configuration

fails—if the device does not find a server or if it cannot get a

configuration from it within one minute—the device assigns

itself temporary network settings based on the APIPA service.

This service allows a device to find a unique IP address until it

receives a complete network configuration, either manually or

from a DHCP server.

A device in APIPA mode does not reside on the same subnet as

the other devices on the IP network; therefore, it may not be

able to see them or be visible to them. Devices use the

following temporary APIPA configuration:

 IP address: 169.254. *. *

 Subnet mask: 255.255.0.0

 Gateway: 169.254. *. *

The *. * portion is based on the MAC address of the device.

A device is in APIPA mode:

 The first time it boots up

 After receiving a duplicate IP address

 After a factory reset

 When the DHCP server does not have any available IP

addresses

DHCP configuration is disabled:

 After a firmware upgrade

 After a factory reset

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 98 99

Sin comentarios

Verint Nextiva S1700e Series Manual de usuario Pagina 84